Upgrading from Vault Standard to Vault Pro 6.0

[jperryco]

I am having the same problem as in this post:
http://support.sourcegear.com/viewtopic ... 48&t=20069
However, I've tried the suggestions and also ready the link provided by the support person in the post. But, the problem is that I have a solution with two projects, and neither of the individual projects will open at all, so I can't unbind them and rebind them - only the main solution. But that doesn't solve the problem.

I was not aware that I should have unbound the projects from source control before upgrading to Vault Pro.

Do you have any suggestions at all?

thanks,
Janet

[Beth]

You can also just manually remove the bindings. Check out this comprehensive article on Binding and Rebinding. You'll see links in the index to manually removing bindings for both the classic and enhanced clients.

If it still gives you problems after trying the suggestions there, send an email to support at sourcegear.com with a link to this forum thread.