If you are having a problem using Vault, post a message here.
- Posts: 147
- Joined: Wed Dec 15, 2004 9:42 pm
I already have one Vault Server running OK since 2004 - ver 3.1.7 running on .Net Framework 1.1
Right now i am attempting to migrate the Vault to a new server - with better hardware specification & also to allow external access.
I am not installing Vault 4.0. I am installing Vault ver 3.1.7. Existing vault server is running on Windows Server 2003 Data Center Edition.
probably uninstall (if you got Vault to install) and reinstall Vault
I wish i have gotten the Vault installed - but no.
I still do not get it why Vault Server installer can't detect the IIS version 6.0 - since i can read it from the registry entry?
- Posts: 8550
- Joined: Wed Jun 21, 2006 8:24 pm
- Location: SourceGear
You can send an email through to support at sourcegear.com (attn: Beth) with a link to this forum thread and we can dig further into your particular case.
SBS 2003 is not different enough from Windows 2003 to make a difference as far as I can tell.
- Posts: 1
- Joined: Fri Jul 20, 2007 9:24 am
I don't know if you're still having this problem, but I had a similar one when installing an application for a school. I was getting the message: "Version 4.00 of IIS is required. Setup will now terminate." and I had just installed v.5. Doing some research I came across that there was another place in the registry that needed to have some values and my server didn't have them. It was in: HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\W3SVC\Parameters
I had to add two dwords: MajorVersion, with a value of 6, and MinorVersion, with a value of 0. After that, the installation went without problems.
Hope it helps,